This video goes over an obscure scenario — a situation where you are using multi-processes in Simplify3D (as separate prints) and you want to use a raft.

02:25 – The challenge with rafts and multi-processes as separate prints
04:00 – Determining the height of your raft
07:07 – Raising the object to accommodate the raft
09:28 – Optional spot checking

If this rare situation applies to you, I hope this video helps. Thank you for watching!

Tis the season for 3D Printed Ornaments! In this video, I’ll go over some techniques and approaches I have used in my ornaments to hang and balance them.

Hanging
0:43 – Poke a Hole in the Piece for a Ribbon or Hook
1:18 – Glue Two Mirrored Pieces Together
2:31 – Include Your Own 3D Printed Clasp into the Design
3:35 – Embed Split/Jump Rings into your Design
Balancing
5:14 – Using Blender for Guidance on the Center of Gravity
6:54 – Adding a Symmetrical Base
7:16 – Adding a Hidden Counterweight

If you are interested in my Etsy shop, that can be found at https://www.etsy.com/shop/vickytgaw Thanks for watching! Have a great day!